Technical FAQs

Ask a Question

Can the existing Full Function Test Kit (FFTK) be used for testing the new Compact NSX MCCB?
Compact NSX can be tested with a new dedicated test kit, Maintenance case reference TRV00910. This TRV00910 test kit works in association with the...
What are the recommended Cable Sizes and the Tightening Torque values for the Multi9 Final Low Voltage (FLV) range of products?
The recommended Cable Sizes and the Tightening Torque values for the Multi9 Final Low Voltage (FLV) range of products is given in the attached document....
What is the difference between 31088 and 31097 key locking devices.
31097 key locking device is used for the Single Handle Source Changeover Assembly in which different type off cam is used. These cams are to be ordered...
Can the OA1 output of Tesys U be used with multi function unit to drive a separate motor contactor.
Output OA1 for Tesys U with base contactor (LUB**) is only used to drive the contactor embedded inside the TesysU contactor base LUB.   In order to use...
What is the new tag point count licensing in Citect SCADA V7.0 ?
In CitectSCADA 6.10 or earlier, multiple tags that share the same I/O device address will be counted as a single I/O point. This is calculated at...
Is it possible to use Altivar 71 Drive for control of the Synchronous Motor.
Yes, Altivar 71 Drive can be used for control of the Synchronous Motor.  Note:   1. The Drive should be programmed for Open-Loop Control.   2. De-rate...
What is the part number of battery (with connector cable) for Modicon Micro range PLC 110CPU31102.
The part reference of the battery for Modicon Micro range PLCs are as follows: Lithium battery assembly 110XCP98000. Battery capacitor assembly 110XCP99000....
What is the heat dissipation of the Altivar 61 Drive when it is in Ready state.
The heat dissipation value of the Altivar 61 Drives when in Ready State (RDY - Drive is powered up but motor is not running) depends on the size of...
What is the heat dissipation (power loss) of the Passive Filter used for the Altivar 71 Drive.
The heat dissipation of the Passive Filter used for the Altivar 71 Drive is 2% of thermal losses. (Passive Filter efficiency is 98%).  Example:  ...
What is the minimum recommended Ground to Input Phase insulation resistance for Altivar 71 Drive.
The Insulation resistance value between Ground to Input Phase should be greater than 1 Mega Ohms which is the Megger value at 500 V for 1 minute.
Results 1 - 10 of 100